Page 5
Basic Copying Procedure
1. Make sure Ready is shown on the display. If any other function is displayed, press the
Copy key.
y Initial copy display
2. Make sure no previous settings remain.
NOTE: When there are previous settings remaining, press the Clear Modes key before
entering your settings.
3. Place the originals.
4. Make the necessary settings.
5. Enter the required number of copies using the number keys.
NOTE: The maximum copy quantity that can be set is between 1 and 999.
6. Press the Start key.
NOTES:
y When placing originals on the exposure glass, press the
# (enter) key after all the
originals are scanned.
y Copies are delivered face down.
To Next Page
Loading...
