Page 6
Copying From the Bypass Tray
This section gives instructions for setting paper on the bypass tray. Use the bypass tray to
print onto OHP transparencies, labels, thick paper, and envelopes that cannot be loaded in the
paper tray.
NOTES:
y When loading letterhead paper, pay attention to its orientation.
y Paper within the following dimensions can be set in the bypass tray:
y Vertical: 100 - 305 mm (3.9 - 12.0 in.)
y Horizontal: 148 - 457.2 mm (5.5 - 18.0 in.)
y Be sure to set the paper with the side you want to print facing down in the bypass tray.
y When loading OHP transparencies or thick paper in the bypass tray, make the paper
setting using the control panel or printer driver.
y The number of sheets that can be loaded in the bypass tray depends on the paper type.
y Paper sizes fed from the bypass tray are output first sheet down, print side-up.
LIMITATION: The following functions are disabled when printing from the bypass tray:
y Duplex printing
y Auto Tray Select
y Auto Tray Switching
y Rotating Collate
y Staple (when the optional unit is installed)
y Punch (when the optional unit is installed)
To Next Page
Loading...
Need help?
General
