1 RESTRICTIONS
24 TopAccess ADMIN Mode
Setting up ODCA (Off Device Customization Architecture)
Setting up Network
The following provided for Network cannot be changed when the controller is connected to the equipment:
y Port Number — The default port number “49629” is always used. This port number cannot be changed.
y SSL Port Number — The default SSL port number “49630” is always used. This port number cannot be changed.
For details on the ODCA screen, refer to the TopAccess Guide.
Security page
Authentication menu
Setting up Department Setting
The following provided for Department Setting differs depending on the equipment with or without the controller:
y Invalid Department Code Print Job — The option “Store to invalid job list” cannot be selected when the controller is
connected to the equipment. You can select either “Print” or “Delete”.
e-STUDIO4540C Series/e-STUDIO6550C Series
e-STUDIO machine with the controller or
e-STUDIO4540C Pro Series/e-STUDIO6550C Pro Series
e-STUDIO4540C Series/e-STUDIO6550C Series
e-STUDIO machine with the controller or
e-STUDIO4540C Pro Series/e-STUDIO6550C Pro Series
To Next Page
Loading...
