2.GA-1211-EX/GA-1310-EX SPECIFIC FUNCTIONS
Operations From the Control Panel 43
2 GA-1211-EX/GA-1310-EX SPECIFIC FUNCTIONS
3
Specify the following item as required and press [OK].
ENABLE LDAP — Press [ENABLE] to enable the LDAP network service, or [DISABLE] to disable it.
4
Continue to another network setting if required, then press [APPLY NOW].
“NETWORK INITIALIZING” is displayed at the lower left of the screen and this equipment starts initializing the
network interface card to apply the changes. This message disappears after it is finished.
To Next Page
Loading...
