2.BASIC OPERATION
Scan to E-mail 33
2 BASIC OPERATION
6
Specify the e-mail address(es) that you want to send to.
1) Press [INPUT @].
2) Enter an e-mail address using the keyboard and digital keys, and then press [OK] to set the entry.
3) Finally, press [OK].
You can specify e-mail addresses in various ways. For details, see the following section:
P.64 “Specifying E-mail Addresses”
The entry in the FROM ADDRESS box ( step 9) may already be set by the administrator on
TopAccess. (Refer to the TopAccess Guide for descriptions of the E-mail Setting and/or the User
Authentication for Scan to E-mail setting.) In this case, you can start sending your scans by
specifying the e-mail address(es) and then pressing [SEND] or the [START] button.
7
Press [SUBJECT] and [BODY] and enter each item.
To clear the settings, press [RESET].
Pressing each button displays an on-screen keyboard. Enter each item using the keyboard and
digital keys, and then press [OK] to set the entry. The maximum number of characters allowed for
each box is as follows:
- [SUBJECT]: 128 characters
- [BODY]: 1000 characters
To add another contact, press [CC] or [BCC] to add the E-mail address of the contact.
When the e-mail is sent, the date and time are automatically added to the subject.
The administrator can change the body text. For details, refer to the MFP Management Guide or
the TopAccess Guide.
Pressing adds a meaningful number, such as date and time, to the subject. For details, refer
to the TopAccess Guide.
To Next Page
Loading...
Need help?
General
