2 SETTING ITEMS (ADMIN)
160 Setting Network Functions
2
Press [OTHER].
The OTHER screen is displayed.
3
Specify the following items as required and press [OK].
ENABLE LDAP — Press [ENABLE] to enable the LDAP network service, or [DISABLE] to disable it.
ENABLE IP FILTERING — Press [ENABLE] to enable the IP filtering function, or [DISABLE] to disable it.
ENABLE MAC ADDRESS FILTERING — Press [ENABLE] to enable the MAC address filtering function, or
[DISABLE] to disable it.
4
Continue to another network setting if required, then press [APPLY NOW].
“NETWORK INITIALIZING” is displayed at the lower left of the screen and this equipment starts initializing the
network interface card to apply the changes. This message disappears after it is finished.
To Next Page
Loading...
