1 BEFORE USING EQUIPMENT
12 Placing Paper
*1 Duplex copying is not available.
*2 Tab paper can be set in any drawer other than the External Large Capacity Feeder (optional) or the bypass tray (the 2nd drawer
recommended).
*3 When a finisher (optional) is installed in the equipment, use 5 or 8-tab paper.
*4 Paper misfeeds may occur depending on the paper characteristics and its condition.
*5 For making copies on the tracing paper, select “PLAIN” for the paper type.
*6 For making copies on the sticker labels, select “THICK 3” for the paper type. Only Toshiba-recommended sticker labels should be
used.
*7 If a copy is made on either A6-R or non-standard size paper with a width of less than 182 mm (7.2"), or on paper of an unregistered
size, the paper exits with its copied side up.
y “LT format” is the standard size only for use in North America.
y “K format” is a Chinese standard size.
y Abbreviations for paper sizes: LT: Letter, LD: Ledger, LG: Legal, ST: Statement, COMP: Computer, SQ:
Square
Bypass tray Plain paper
(64 - 80 g/m
2
)
(17 - 20 lb. Bond)
100 sheets A/B format:
A3, A4, A4-R, A5-R, A6-R
*7
,
B4, B5, B5-R, FOLIO
LT format:
LD, LG, LT, LT-R, ST-R,
COMP, 13"LG, 8.5"SQ
K format:
8K, 16K, 16K-R
Non-standard size:
Length: 100 - 297 mm (3.9" -
11.7"),
Width: 148 - 432 mm (5.8" -
17")
*7
THICK 1
(81 - 105 g/m
2
)
(21 - 28 lb. Bond)
80 sheets
THICK 2
(106 - 163 g/m
2
)
(29 lb. Bond - 90 lb.
Index)
40 sheets
THICK 3
(164 - 209 g/m
2
)
(91 - 110 lb. Index)
30 sheets
Tracing paper
*1, *5
(75 g/m
2
)
(20 lb. Bond)
—
Sticker labels
*1, *6
—
Tab paper
*1, *2, *3
—A4, LT
OHP film
*1
30 sheets A4, LT
Feeder Paper type Maximum sheet capacity Size
To Next Page
Loading...
