Toshiba e-STUDIO557 - Chapter 3 BASIC COPY MODES; Before Using Copying Functions; Default Settings; Confirming the Set Functions

3 BASIC COPY MODES
48 Before Using Copying Functions
Before Using Copying Functions
 Default settings
This equipment is under its “default settings” when the power is turned ON, namely, if no setting change has
been applied yet, the equipment’s settings return to the default ones when the energy saving mode is cleared
or the [FUNCTION CLEAR] button on the control panel is pressed. The default settings for basic copy modes
at installation are shown below.
The default settings are changeable. For details, refer to the MFP Management Guide.
 Confirming the set functions
If you press [SETTINGS] on the touch panel, the menu shown below is displayed. On this menu, you can view
the functions that are currently set.
Item Default setting
Reproduction ratio 100%
Copy quantity 1
Paper selection Automatic Paper Selection (APS)
Simplex/Duplex 1-sided original -> 1-sided copy
Density adjustment Automatic adjustment
Original mode TEXT/PHOTO
Finishing mode When using the original glass:
NON-SORT NON-STAPLE
When using the RADF (Reversing Automatic
Document Feeder):
SORT
Feeding mode when using the RADF Continuous feed mode