Toshiba e-STUDIO557 - Selecting Finishing Mode; Finishing Modes and Optional Finishing Devices

3 BASIC COPY MODES
62 Selecting Finishing Mode
Selecting Finishing Mode
 Finishing modes and optional finishing devices
See the table below for each finishing mode.
The available finishing modes differ depending on the type of optional finishing devices (Finisher, Hole Punch
Unit and Inserter) installed. Finishing devices available for this equipment are as follows:
Finisher
y Finisher MJ-1027
y Saddle Stitch Finisher MJ-1028/MJ-1029
Hole Punch Unit
Hole Punch Unit MJ-6003
Inserter
Inserter MJ-7001
Check the finishing modes enabled with each finishing device.
Finishing mode Description
Non-sort Non-staple Copies exit without being sorted or stapled.
Sort ( P.65) Copies exit in the same page order as the originals one set after
another.
Group ( P.65) Copies grouped by page exit.
Rotate sort ( P.66) Copies exit set by set alternately in a different direction.
Staple sort ( P.67) Copies exit with their corner stapled.
Magazine sort ( P.69) Copies exit in a book-type page order.
Saddle stitch ( P.69) Copies exit in a book-type page order with their center folded and
stapled.
Magazine sort & saddle stitch
( P. 6 9 )
Magazine sort and saddle stitch are used together.
Hole punch ( P.71) Copies exit with their side punched.
Inserter mode ( P.72) Stapling and hole punching the sheets without making copies
Finishing mode
Devices
MJ-1027 &
MJ-6003 &
MJ-7001
MJ-1027 &
MJ-6003
MJ-1027 &
MJ-7001
MJ-1027
MJ-1028/1029
&
MJ-6003 &
MJ-7001
Non-sort Non-staple Yes Yes Yes Yes Yes
Sort Yes Yes Yes Yes Yes
Group Yes Yes Yes Yes Yes
Rotate sort Yes Yes Yes Yes Yes
Staple sort Yes Yes Yes Yes Yes
Magazine sort Yes Yes Yes Yes Yes
Saddle stitch ————Yes
Magazine sort & saddle
stitch
————Yes
Hole punch Yes Yes — — Yes
Manual staple Yes — Yes — Yes