3 BASIC COPY MODES
66 Selecting Finishing Mode
Rotate sort mode
When you make more than one set of copies, one set can be made to exit on top of another set, alternating in
portrait and landscape directions. This mode is called the rotate sort mode. Use 2 drawers and 2 stacks of
paper of the same size. Place one stack of paper in one drawer in a portrait direction and place the other in
another drawer in a landscape direction before you start copying.
y A4, B5 and LT sized paper placed on the drawer or bypass tray can be used.
y The rotate sort mode is not available when Automatic Paper Selection is selected.
1
Place paper in the drawer(s).
Place one stack of paper in one drawer in a portrait direction and place the other in another drawer
in a landscape direction.
2
Place the original(s).
3
Press [FINISHING] on the touch panel.
4
Select [ROTATE SORT], and then press [OK].
5
Key in the desired number of copies.
6
Select other copy modes as required, and then press the [START] button on the control
panel.
To Next Page
Loading...
