3 BASIC COPY MODES
60 Enlargement and Reduction Copying
Specifying reproduction ratio manually
1
Place paper in the drawer(s).
2
Place the original(s).
3
Press [ZOOM] on the touch panel.
4
Press the buttons below to select the desired reproduction ratio.
[ UP] and [ DOWN] buttons
The reproduction ratio changes by 1% every time either of them is pressed. When you hold either
down, the ratio goes up or down automatically.
One-touch zoom buttons
Select the desired ratio from [400%], [200%], [100%], [50%] and [25%].
When the RADF is used, the maximum ratio available is 200%.
5
Select the desired size, and then press [OK].
y If you want to select a paper size other than the following, you need to register the size as
“OTHER”. Once you register this size, it will be specified every time you press [OTHER] on the
touch panel.
North America: LD, LG, LT, ST
Other than North America: A3, A4, B4, B5
For how to register, see the following page:
P.59 “Registering paper sizes to “OTHER” size”
y Paper sizes can also be registered by pressing the desired drawer button of the equipment
status indication area on the BASIC menu.
To Next Page
Loading...
