1.BEFORE USING EQUIPMENT
Placing Paper 15
1 BEFORE USING EQUIPMENT
10
Push the drawer straight into this equipment carefully until it comes to a stop.
Be careful not to let your fingers be caught when pushing the drawer into this equipment.
This could injure you.
6
Place paper in the drawer.
y Up to 550 sheets (64 g/m
2
) (17 lb. Bond) can be placed in
one drawer. Be sure that the height of the stacked paper
does not exceed the line indicated inside of the side
guides.
P.11 “Acceptable copy paper”
y Fan and jog the stack of paper well before you place it in
a drawer, or the sheets may not be separated before
being fed. Be careful not to cut your fingers when
fanning.
y Place paper with its copy side down. The copy side may
be noted on its wrapping paper.
7
Adjust the side guides.
Make sure that a gap (“A” in the figure on the right) of 0.5 mm
(0.02") (1.0 mm (0.04") or less in total)
*1
is left between the
paper and the side guide for plain paper. If the gap is
inappropriate, it could cause paper misfeeding.
*1 For thick paper, the gap must be 0.5 mm (0.02") to 1.0 mm (0.04") (1.0 mm
(0.04") to 2.0 mm (0.08") in total).
8
Push the part shown with an arrow (left side) to lock
the side guide.
9
Change the paper size indicator if required.
A
To Next Page
Loading...
