3 BASIC COPY MODES
70 Selecting Finishing Mode
The magazine sort mode can also be selected on the EDIT menu. If you select it on the EDIT menu, you can
adjust the binding margin. For details, see the following page:
P.97 “Magazine Sort Mode”
1
Place paper in the drawer(s).
Special paper such as OHP film or sticker labels is not applicable.
2
Select the desired paper size.
A3, A4-R, A5-R
*1
, B4 or B5-R
*1
size paper can be used.
*1 A5-R and B5-R are acceptable only for the magazine sort mode.
3
Place the original(s).
When placing the originals on the RADF, place them according to the illustration on the previous page.
When placing the originals on the original glass, place them in the following order:
Magazine sort, Magazine sort & saddle stitch: Place the first page of the original first.
Saddle stitch: For example, if the total number of pages is 12, place pages 1 and 12 together, and
then pages 2 and 11, 10 and 3, 4 and 9, 8 and 5, and finally pages 6 and 7.
4
Press [FINISHING] on the touch panel.
5
Select the desired mode from [MAGAZINE SORT], [MAGAZINE SORT & SADDLE
STITCH] and [SADDLE STITCH]. Then press [OK].
Modes other than [MAGAZINE SORT] are selectable only when the Saddle Stitch Finisher (optional)
is installed.
6
Select other copy modes as required, and then press the [START] button on the control
panel.
To Next Page
Loading...
