1.TROUBLESHOOTING FOR THE HARDWARE
Messages Displayed on the Touch Panel 17
TROUBLESHOOTING FOR THE HARDWARE
Error Codes
The error codes indicating the status of the equipment may appear on the touch panel. For details, please refer to the
Software Troubleshooting Guide.
Check under the Finisher tray
and reboot the machine.
An obstruction is placed under
the Finisher tray.
Remove the obstruction under the Finisher
tray and reboot the equipment.
The number of originals
exceeds the limits.
The scanned data will be
deleted.
The number of originals to be
scanned has exceeded the limit
of 1000 sheets during scanning.
(The magazine sort or page
number function is used.)
Reduce the number of originals to be
scanned, and try again.
The number of originals
exceeds the limits.
Will you copy stored originals?
The number of originals to be
scanned has exceeded the limit
of 1000 sheets during scanning.
To print out the data for the originals stored
(scanned) until the message appeared, press
[Yes] on the touch panel. To delete the stored
data, press [No].
LAN cable is not detected The LAN cable connection is not
detected.
Check the following items.
Check that the LAN cable is connected to
the equipment.
Check that there is no damage on the
connector of the LAN cable.
Check that the LAN cable is open circuited.
Check that the LAN cable is connected to
the HUB. Check that there is no damage to
the connector.
Check that the power is ON for the HUB to
which the LAN cable is connected.
Check that the settings of the
communication speed and the Ethernet
method for the equipment and the HUB are
aligned.
Message Problem Description Corrective Action
To Next Page
Loading...
