2. Setting up Network Server
Network Administration Guide — Setting up NetWare Print Server 67
25. Select “((NONE))” in the “Printer Type” list and select “Novell
Port Handler” in the “Port Handler Type” list. Then click
[OK].
• The Configure Port Handler for Printer Agent dialog box appears.
26. Continue the procedure according to which connection type
to be used.
P.67 "Configuring the LPR connection in the TCP/IP network"
P.67 "Configuring the queue based connection in the IPX/SPX network"
Configuring the LPR connection in the TCP/IP network
1. In the Configure Port Handler for Printer Agent dialog box,
select “Novell LPR Printer Gateway (SNMP)” (or “Remote
(LPR on IP)”) and click [Next].
2. Enter the IP address of this equipment in the “Host Address”
field, and enter “PORT_PASSTHROUGH” in the “Printer
Name” field. Then click [Finish].
• It takes about 60 seconds to load the Printer Agent. After it finishes loading
the Printer Agent, the Select Printer Drivers dialog box appears.
3. Select the printer drivers to be installed in the “Printer Driv-
ers” list at each OS tab, and click [Continue].
• The Information dialog box appears.
4. Click [OK].
• It takes about 60 seconds to complete the creation of the NDPS Printer
object.
5. Double-click the NDPS Printer object that you created.
• The NDPS Printer dialog box appears.
6. Click [NDPS Remote Printer Management].
7. Check the “Install to workstation in this container” and click
[Update].
8. Click [OK] to close the NDPS Printer dialog box.
Configuring the queue based connection in the IPX/SPX network
1. In the Configure Port Handler for Printer Agent dialog box,
select “Forward Jobs to a Queue” and click [Next].
2. Enter the NDS queue name in the “Queue Name” field and
the user name in the “Queue User Name” field. Then click
[Finish].
• The Select Printer Drivers dialog box appears.
To Next Page
Loading...
