194 ACE-tronics G9 ASD Installation and Operation Manual
Panel Tension Torque Bias
Program Special Operation Panel Parameters
This function is not used with the ACE-tronics G9 ASD.
The Tension Torque Bias selection is performed at F423.
Direct Access Number — F727
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — -250.00
Maximum — +250.00
Units — %
Panel Load Sharing Gain
Program Special Operation Panel Parameters
This function is not used with the ACE-tronics G9 ASD.
The Load Sharing Gain selection is performed at F424.
Direct Access Number — F728
Parameter Type — Numerical
Factory Default — 100.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.00
Units — %
Panel Override Multiplication Gain
Program Special Operation Panel Parameters
This parameter provides a value to be used in the event that Setting (F729) is
selected for the Frequency Override Multiplying Input (F661).
Direct Access Number — F729
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — -100.00
Maximum — 100.00
Units — %
Panel Frequency Lockout
Program Special Operation Panel Parameters
This function is not used with the ACE-tronics G9 ASD.
Settings:
Unlocked
Locked
Direct Access Number — F730
Parameter Type — Selection List
Factory Default — Unlocked
Changeable During Run — Yes
Panel Emergency Off Lockout
Program Special Operation Panel Parameters
This function is not used with the ACE-tronics G9 ASD.
Settings:
Unlocked
Locked
Direct Access Number — F734
Parameter Type — Selection List
Factory Default — Unlocked
Changeable During Run — No
Panel Reset Lockout
Program Special Operation Panel Parameters
This function is not used with the ACE-tronics G9 ASD.
Settings:
Unlocked
Locked
Direct Access Number — F735
Parameter Type — Selection List
Factory Default — Unlocked
Changeable During Run — Yes
F727 F735
efesotomasyon.com -Toshiba inverter,drive,servo,plc
To Next Page
Loading...
