Toshiba G9 - Page 214

204 ACE-tronics G9 ASD Installation and Operation Manual
Communications Option (DeviceNet/Profibus) Setting 8
Program  Communications  Communication
While using the DeviceNet/Profibus communications protocol, parameters
F841 – F846 allow the user to select the ASD memory location that holds the
Command/Frequency/Monitoring instructions to be applied to the ASD for
Communications Option Settings 8 – 13, respectively.
See the DeviceNet Option Instruction Manual (P/N 58683) for additional
information on this parameter.
Settings:
Disabled
FD01 (ASD Status 1)
FD00 (Output Frequency, 0.01 Hz)
FD03 (Output Current, 0.01%)
FD05 (Output Voltage, 0.01%)
FC91 (ASD Alarm)
FD22 (PID Feedback Value, 0.01 Hz)
FD06 (Input Terminal Status)
FD07 (Output Terminal Status)
FE36 (V/I)
FE35 (RR Input)
FE37 (RX Input)
FD04 (Input Voltage [DC Detection], 0.01%)
FD16 (Realtime Speed Feedback
FD18 (Torque, 0.01%)
FE60 (My Monitor)
FE61 (My Monitor)
FE62 (My Monitor)
FE63 (My Monitor)
F880 (Free Notes)
FD29 (Input Power, 0.01 kW)
FD30 (Output Power, 0.01 kW)
FE14 (Cumulative Operation Time, 0.01=1 Hour)
FE40 (FM Terminal Output Monitor)
FE41 (AM Terminal Output Monitor)
Direct Access Number — F841
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communications Option (DeviceNet/Profibus) Setting 9
Program  Communications  Communication
Same as F841. See F841 for information on this parameter
Direct Access Number — F842
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communications Option (DeviceNet/Profibus) Setting 10
Program  Communications  Communication
Same as F841. See F841 for information on this parameter
Direct Access Number — F843
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communications Option (DeviceNet/Profibus) Setting 11
Program  Communications  Communication
Same as F841. See F841 for information on this parameter
Direct Access Number — F844
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
F841 F844
efesotomasyon.com -Toshiba inverter,drive,servo,plc