210 ACE-tronics G9 ASD Installation and Operation Manual
Block Read Data 4
Program Communications Communication
This parameter plays a role in the setup of the communications network by
establishing the type of data to be read from the ASD of the communications
link.
See parameter F875 for additional information on this setting.
Direct Access Number — F878
Parameter Type — Selection List
Factory Default — None
Changeable During Run — Yes
Block Read Data 5
Program Communications Communication
This parameter plays a role in the setup of the communications network by
establishing the type of data to be read from the ASD of the communications
link.
See parameter F875 for additional information on this setting.
Direct Access Number — F879
Parameter Type — Selection List
Factory Default — None
Changeable During Run — Yes
Free Notes
Program Communications Communication
This is an unused parameter that has allocated memory space.
The space may be used at the discretion of the user. This space may be used to
store information or a note to be transferred using communications.
Direct Access Number — F880
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 65534
Network Option Reset
Program Communications Communication
This parameter plays a role in the setup of the communications network by
establishing the targets of a Reset command received via the communications
link.
Settings:
Reset ASD only
Reset Option Board and ASD
Direct Access Number — F899
Parameter Type — Selection List
Factory Default — Reset ASD only
Changeable During Run — Yes
Input Function Target 1
Program My Function My Function Unit 1
This parameter plays a role in the setup of the My Function feature by
selecting the functionality of the programmable Input Function Target 1
terminal.
This setting assigns the function of the programmable Input Function Target 1
terminal to any one of the user-selectable functions listed in
Table 9 on pg. 241,
Table 10 on pg. 242, or Table 12 on pg. 245.
See F977 for additional information on this parameter.
Direct Access Number — F900
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Input Function Command 1
Program My Function My Function Unit 1
This parameter is used to assign a user-selected logical operator to two user-
selected Input Function Target variables, enable a counter/timer function, or
perform a hold/Reset function.
Table 13 on pg. 247 lists the available selections. Their use and selection
requirements are described in an example at F977.
Direct Access Number — F901
Parameter Type — Selection List
Factory Default — 0 (NOP)
F878 F901
efesotomasyon.com -Toshiba inverter,drive,servo,plc
To Next Page
Loading...
