Toshiba H7 - Page 152

H7 ASD Operation Manual 145
Group #1 Speed #6
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F536
Parameter Type — Selection List
Factory Default — 6
Changeable During Run — No
Group #1 Speed #7
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F537
Parameter Type — Selection List
Factory Default — 7
Changeable During Run — No
Group #1 Speed #8
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F538
Parameter Type — Selection List
Factory Default — 8
Changeable During Run — No
Group #2 Speed Repeat Factor
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
This parameter sets the number of times that the enabled preset speeds of
Group #2 will be run; 0 – 254 or Infinite.
Direct Access Number — F540
Parameter Type — Selection List
Factory Default — 1
Changeable During Run — No
Group #2 Speed #1
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F541
Parameter Type — Selection List
Factory Default — 9
Changeable During Run — No
Group #2 Speed #2
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F542
Parameter Type — Selection List
Factory Default — 10
Changeable During Run — No
Group #2 Speed #3
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F543
Parameter Type — Selection List
Factory Default — 11
Changeable During Run — No
Group #2 Speed #4
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F544
Parameter Type — Selection List
Factory Default — 12
Changeable During Run — No
F536 F544
www . ElectricalPartManuals . com