Toshiba H7 - Page 153

146 H7 ASD Operation Manual
Group #2 Speed #5
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F545
Parameter Type — Selection List
Factory Default — 13
Changeable During Run — No
Group #2 Speed #6
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F546
Parameter Type — Selection List
Factory Default — 14
Changeable During Run — No
Group #2 Speed #7
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F547
Parameter Type — Selection List
Factory Default — 15
Changeable During Run — No
Group #2 Speed #8
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F548
Parameter Type — Selection List
Factory Default — Skip
Changeable During Run — No
Group #3 Speed Repeat Factor
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
This parameter sets the number of times that the enabled preset speeds of
Group #3 will be run; 0 – 254 or Infinite.
Direct Access Number — F550
Parameter Type — Selection List
Factory Default — 1
Changeable During Run — No
Group #3 Speed #1
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F551
Parameter Type — Selection List
Factory Default — 1
Changeable During Run — No
Group #3 Speed #2
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F552
Parameter Type — Selection List
Factory Default — 2
Changeable During Run — No
Group #3 Speed #3
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F553
Parameter Type — Selection List
Factory Default — 3
Changeable During Run — No
F545 F553
www . ElectricalPartManuals . com