Toshiba H7 - Page 154

H7 ASD Operation Manual 147
Group #3 Speed #4
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F554
Parameter Type — Selection List
Factory Default — 4
Changeable During Run — No
Group #3 Speed #5
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F555
Parameter Type — Selection List
Factory Default — 5
Changeable During Run — No
Group #3 Speed #6
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F556
Parameter Type — Selection List
Factory Default — 6
Changeable During Run — No
Group #3 Speed #7
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F557
Parameter Type — Selection List
Factory Default — 7
Changeable During Run — No
Group #3 Speed #8
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F558
Parameter Type — Selection List
Factory Default — 8
Changeable During Run — No
Group #4 Speed Repeat Factor
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
This parameter sets the number of times that the enabled preset speeds of
Group #4 will be run; 1 – 254 or Infinite.
Direct Access Number — F560
Parameter Type — Selection List
Factory Default — 1
Changeable During Run — No
Group #4 Speed #1
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F561
Parameter Type — Selection List
Factory Default — 9
Changeable During Run — No
Group #4 Speed #2
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F562
Parameter Type — Selection List
Factory Default — 10
Changeable During Run — No
F554 F562
www . ElectricalPartManuals . com