Toshiba H7 - Page 155

148 H7 ASD Operation Manual
Group #4 Speed #3
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F563
Parameter Type — Selection List
Factory Default — 11
Changeable During Run — No
Group #4 Speed #4
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F564
Parameter Type — Selection List
Factory Default — 12
Changeable During Run — No
Group #4 Speed #5
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F565
Parameter Type — Selection List
Factory Default — 13
Changeable During Run — No
Group #4 Speed #6
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F566
Parameter Type — Selection List
Factory Default — 14
Changeable During Run — No
Group #4 Speed #7
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F567
Parameter Type — Selection List
Factory Default — 15
Changeable During Run — No
Group #4 Speed #8
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Same as #1 Group Speed #1 (see F531).
Direct Access Number — F568
Parameter Type — Selection List
Factory Default — Skip
Changeable During Run — No
Pattern #1 Characteristics (Pattern Run)
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds ⇒ 1
In conjunction with the setting of F585, this parameter is used to set the run-
time of Preset Speed 1 when used as part of a Pattern Run.
Settings:
Time From Start
Time From Reach
No Limit
Until Next Step
Direct Access Number — F570
Parameter Type — Selection List
Factory Default — Time From Start
Changeable During Run — No
F563 F570
www . ElectricalPartManuals . com