Toshiba H7 - Page 173

166 H7 ASD Operation Manual
Frequency Display Resolution
Program ⇒ Utility Parameters ⇒ Display Units
The parameter sets the number of decimal places to be displayed during non-
Accel/Decel functions.
Direct Access Number — F703
Parameter Type — Numerical
Factory Default — 0.1
Changeable During Run — Yes
Minimum — 1
Maximum — 0.01
Accel/Decel Special Display Resolution
Program ⇒ Special Control Parameters ⇒ Accel/Decel Special
This parameter sets the number of decimal places to be displayed for Accel/
Decel functions.
Direct Access Number — F704
Parameter Type — Numerical
Factory Default — 0.1
Changeable During Run — Yes
Minimum — 1
Maximum — 0.01
Prohibit Initializing User Parameters During Typeform
Initialization
Program ⇒ Special Control Parameters ⇒ Special Parameters ⇒
Prohibit Initializing User Parameters During Typeform Initialization
This parameter Enables/Disables the ability to initialize user parameters during
a Type Form initialization.
Settings:
Allowed
Prohibited
Direct Access Number — F709
Parameter Type — Selection List
Factory Default — Allowed
Changeable During Run — Yes
V/f Group
No path available (Direct Access Only)
While operating using the LED Keypad Option 1 of 4 V/f groups may be
selected and run. Each V/f group is comprised of 4 user-defined variables: Base
Frequency, Base Frequency Voltage, Manual Torque Boost, and Electronic
Thermal Protection. Expanded descriptions of these parameters may be found
in this section (Direct Access Parameter Information).
Note: If using the LCD EOI, press ESC from the Frequency Command screen
to access this parameter.
Direct Access Number — F720
Parameter Type — Selection List
Factory Default — 1
Changeable During Run — Yes
F703 F720
www . ElectricalPartManuals . com