Toshiba H7 - Page 81

74 H7 ASD Operation Manual
OUT1 On Delay
Program ⇒ Terminal Selection Parameters ⇒ Output Terminal Delays
⇒ OUT1
Once the condition is met to close the OUT1 (A & C) output terminals, this
parameter delays the closing of the terminals by the programmed value.
For example, if the OUT1 function is programmed as Overtorque Alarm,
OUT1 will close 2.0 mS (the default value for OUT1 On Delay) after the
overtorque condition occurs.
The delay may be increased to prevent relay chatter.
Direct Access Number — F150
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT2 On Delay
Program ⇒ Terminal Selection Parameters ⇒ Output Terminal Delays
⇒ OUT2
This parameter delays the closing of the OUT2 (A & C) output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
Direct Access Number — F151
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
FL On Delay
Program ⇒ Terminal Selection Parameters ⇒ Output Terminal Delays
⇒ FL
This parameter delays the closing of the FL output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
Direct Access Number — F152
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT4 On Delay
Program ⇒ Terminal Selection Parameters ⇒ Output Terminal Delays
⇒ OUT4
This parameter delays the closing of the OUT4 output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
Direct Access Number — F153
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
F150 F153
www . ElectricalPartManuals . com