Toshiba HWS-804XWHM3 series - Hydro Unit Function Code Access Procedures; Accessing Hydro Unit Function Codes; Accessing Remote Controller Function Codes

30
Function Code Access
Set function codes for various operation modes, input using the remote controller.
There are 2 types of settings:-
1) Hydro Unit function code setting.
2) Remote controller function code setting.
Setting procedure for Hydro Unit function code
1. Press and hold + + buttons for four
seconds or more to enter the hydro unit function code setting mode.
2. Set the function code number with the TEMP. buttons
(CODE No.: 01 to B2).
3. Set data with the TIME buttons .
4. Press to confirm the settings.
5. Note that the Clear button is enabled only before the SET
button is pressed and the function code is changed.
6. Press to exit the settings menu.
Setting procedure for Remote Controller function code
1. Press and hold + + TEMP. buttons for four seconds
or more to enter the remote controller function code setting mode.
2. Set the function code number with the TEMP. buttons
(CODE No.: 01 to 13).
3. Set data with the TIME buttons .
4. Press to determine the settings.
5. Note that the Clear button is enabled only before the SET
button is pressed and the function code is changed.
6. Press to exit the settings menu.