Toshiba HWS-804XWHM3 series - Hydro Unit Hot Water Boost Control Setup; Setting Hot Water Boost Function Codes

52
7. Hot water boost control (hot water mode)
The hot water boost function can be used when there is a high demand for hot water. The boost
function will heat the cylinder water to the set point temperature quicker than the time taken during
normal hot water production.
 Set the following function codes for the hot water boost function:
 FC08: Sets the duration of the hot water boost function
 FC09: Sets the set point temperature, of the water in the cylinder, to be achieved during the
hot water boost function
 When the above function codes have been set then the hot water boost function is activated by
pressing on the ESTIA remote controller
 When the hot water boost function is active the following symbol is shown on the ESTIA remote
controller display