HX7+ ASD Quick Start Guide 39
System Configuration and Menu Options
Root Menus
The Mode key accesses the three primary screens of the HX7+ ASD: the Frequency Command screen, the
Monitor screen, and the Program screen. From either screen, press the Mode key to loop through to the
other two screens (see Figure 23). While on the Frequency Command screen, pressing the ESC key
toggles the menu to and from the Panel menu and the Frequency Command screen.
Note: Parameter changes made from the Panel menu are effective for Local keypad control
Only.
Figure 23. HX7+ ASD Root Menu Mapping.
Frequency Command Screen
Frequency Setting
While operating in the Local mode (Local|Remote LED is illuminated), the running frequency of the
motor may be set from the Frequency Command screen. Using the Rotary Encoder, enter the Frequency
Command value and then press the Run key. The motor will run at the Frequency Command speed and
may be changed while running.
Scrolling Monitor
The Output Current and the ASD Load values are displayed below the Frequency Command parameter of
the Frequency Command screen (default setting). Other user-selected parameters may be displayed on
this screen for quick-access monitoring while running. These parameters may be accessed and enabled for
display by placing a check in the box next to the item listed at Program Monitor Setup Scrolling
Monitor. If no parameters are enabled for display, No Items is displayed.
When more than two items are selected for display the items are scrolled automatically. The display time
for each selected item may be set from 1 to 60 seconds. The parameters that may be displayed on the
Scrolling Monitor are listed in the section titled Monitor Screen on pg. 44.
To Next Page
Loading...
