Toshiba IP5000 - Setting the IP Telephone Headset Transmit Volume; Viewing IP Telephone Terminal Information

Administrator Programming
Setting the IP Telephone Headset Transmit Volume
110 Strata CIX IP5000-series Telephone UG 10/08
Setting the IP Telephone Headset Transmit
Volume
1. Press 3+6+9+ (simultaneously).
2. Press
#.
3. Press
4. Press the Feature Buttons to turn the LEDs On/Off for the desired volume
transmission level (see Table 16).
5. Press FB4 for headset voice output in speakerphone mode (LED On = with, LED
Off = without).
6. Press to set the above data.
7. Go off-hook and hang up.
Viewing IP Telephone Terminal Information
1. Press 3+6+9+ (simultaneously).
2. Press
1, then press .
3. Press
FB1 to view IPT firmware version (application and boot versions, read
only).
4. Press
FB2 to view IPT MAC address (read only).
5. Lift the handset off-hook / on-hook to save the settings.
Note FB03 will display the Regional Code (default 0); FB04 will display the
connecting IPU address.
Table 16 Volume Level Transmitted from Headset Microphone
LEDS
Transmit Level
FB3 FB2 FB1
ON ON ON Level 7 (min.)
ON ON OFF Level 6
ON OFF ON Level 5
ON OFF OFF Level 4
OFF ON ON Level 3 (initial value)
OFF ON OFF Level 2
OFF OFF ON Level 1
OFF OFF OFF Level 0 (max.)