Feature Operations
Speed Dial
72 Strata CIX IP5000-series Telephone UG 10/08
Storing a System/Station Speed Dial Number
1. Dial #66. The display shows “SPEED DIAL” and you hear Entry Tone.
2. Dial the Station Speed Dial number (100~199) or System Speed Dial number
(200~999). The LCD shows your digits and you hear Entry Tone.
3. Dial the telephone number to be stored +
#. Include any required access and area
codes. The LCD shows “SPEED DIAL” + the Speed Dial Number + destination +
#. You hear Success Tone.
4. Lift handset.
5. To enter another number repeat steps 1-4. Refer to Table 9 below.
Example: To store a Station Speed Dial number to Speed dial location 100, dial
#66 + 100 + 99495833000 + #
Speed Dial (Storing an SD number)
#66 + nnn + Phone No.
2
+ #
nnn = 100~199 SD bin numbers
#66 + nnn + Phone No.
2
+ #
nnn = 200~999 SD bin numbers
Table 8 Speed Dial Access Codes
Feature Feature Access Code Sequences
Speed Dial (Dialling an SD number)
Station
1
Spdial
2
+ nnn
nnn = 100~199 Station SD numbers
System
1
Spdial
2
+ nnn
nnn = 200~999 System SD numbers
1. Stations must be assigned/enabled Speed Dial capabilities in system programming by an
Administrator in Program 200-30 (System SD) and Program 200-35 (Station SD).
2. If your telephone does not have a Spdial button, press the
*
button, then dial the three digit
Speed Dial bin number (nnn).
Table 9 Feature Access Codes
Feature Feature Access Code Sequences
Station
1
1. Stations must be assigned/enabled Speed Dial capabilities in system programming by an
Administrator in Program 200-30 (System SD) and Program 200-35 (Station SD).
2. Refer to Table 10 on page 73 to see how to enter
*
and # into a speed dial phone number.
System
1
To Next Page
Loading...
