19
Setting Up the dynadock™ and Connecting Peripherals
3 Follow the on-screen instructions to finish the installation.
You will need to read and accept the TOSHIBA software license
agreement when prompted, to proceed with the installation.
4 Restart your computer if prompted.
Complete the software installation process before connecting the
dynadock™ to your computer.
Restarting may take longer than usual if the computer's operating
system is configured to create a system restore point after a new
device is installed. This occurs after initial installation only. When
the computer restarts, the dynadock™ is ready to use.
Assemble the dynadock™
Slide the dynadock™ onto the base as shown below.
(Sample Illustration) Attaching the base to the dynadock™
To Next Page
Loading...
