21
Setting Up the dynadock™ and Connecting Peripherals
To disconnect the dynadock™ from your computer, directly unplug
the cable from the computer. The computer is now undocked.
If a USB storage device is connected to the dynadock™, make sure
you save the data located on the USB device, and then remove the
USB device first before undocking.
Connecting your peripherals
Once you have set up a USB cable connection between your
computer and the dynadock™, you can then connect your computer
peripherals to the appropriate ports on the dynadock™.
Connecting your external displays
The dynadock™ provides DVI and HDMI
®
dual output ports. You
can connect a digital (DVI) or analog (VGA) display via the DVI-I
video port and an HDMI
®
display to the HDMI
®
out port on the
dynadock™. Two displays can be connected to the dynadock™ at
the same time.
The dynadock™ U3.0 ( ) icon appears in the system tray after
connecting an external display to the dynadock™.
Connecting to the DVI-I video port
To connect a display to the DVI-I video port on the dynadock™:
1 If you are connecting a VGA display, attach the DVI-I to VGA
adaptor (included with the dynadock™) to the DVI-I video
port on the dynadock™.
2 Connect the display cable (not included) to the DVI-I video
port on the dynadock™ or to the adaptor you connected in
step 1.
3 Connect the other end of the cable to the external display.
The dynadock™ may not support VGA displays using Extended
Display Identification Data (EDID).
Connecting to the HDMI
®
out port
To connect a display to the HDMI
®
out port on the dynadock™:
1 Plug one end of the HDMI
®
cable (not included) into the
HDMI
®
in port on the HDMI
®
display.
To Next Page
Loading...
