29
Using the dynadock™ and Adjusting Settings
2 Select Extend or Mirror from the menu.
If the icon is not visible in your system tray/notification area, make
sure the dynadock™ is connected and docked, and then click the
Show Hidden Icons button ( ), if necessary, to display hidden
icons.
If you notice certain windows or other parts of your display are
missing when you disconnect your computer from the dynadock™,
you may need to de-select the Extend desktop onto this display
checkbox in your Windows
®
Display settings to return the entire
image to your primary screen.
You can also use the Windows
®
Display settings to switch between
Extended mode and Mirror mode.
The external displays connected to the dynadock™ may be identified
as “2”, “3”, or “4” on the Windows
®
Display settings (depending on
your computer model), even though there may not be four viewable
displays.
Supported display modes
Two components make up the display mode: Resolution and
Refresh rate. These components are defined as follows:
❖ Resolution: The number of pixels displayed on the screen
horizontally and vertically.
❖ Refresh rate: The speed at which the entire screen is
re-scanned. Higher frequencies reduce flicker.
To Next Page
Loading...
