4 Replacement Procedures 4.4 Expansion Memory module
4.4 Expansion Memory module
CAUTION: The power of the computer must be turned off when you remove the memory
module. Removing a memory module with the power on risks damaging the
module or the computer itself.
Do not touch the memory module terminals. Any dirt on the terminals may
cause memory access problems.
Never press hard or bend the memory module.
Removing the Expansion memory module
To remove the expansion memory module, follow the steps below and refer to Figure 4-4.
1. Turn the computer upside down.
2. Loosen the screw (with e-ring) and remove the memory slot cover.
3. Press the two latches outward and remove the memory module.
Screw (e-ring)
Memory slot cover
Latch
Latch
Memory module
Figure 4-4 Removing the memory module
4-12 [CONFIDENTIAL] PORTEGE R200 Maintenance Manual (960-519)
To Next Page
Loading...
