Toshiba Portege R200 - SD Card Slot; Procedure 1 Check on Windows; Procedure 2 Connector Check and Replacement Check

2.15 SD card slot 2 Troubleshooting
2.15 SD card slot
To check if the SD card slot is good or no good, follow the troubleshooting procedures below
as instructed.
Procedure 1: Check on Windows
Procedure 2: Connector Check and Replacement Check
Procedure 1 Check on Windows
Insert a SD card into the slot. Check if the installed Windows OS recognizes automatically the
SD card and the data in the SD card can be read.
If the card is nor recognized or data are not read, go to Procedure 2.
Procedure 2 Connector Check and Replacement Check
The SD card is connected to the connector IS2101 on the system board.
SD card
System board
IS2101
Check 1 Check the SD card is firmly inserted to the connector IS2101 of the system board.
If not, insert it firmly. If the SD card is still not functioning properly, perform
Check 2.
Check 2 The SD card may be faulty. Replace it with a new one. If the problem persists,
perform Check 3.
Check 3 The system board may be faulty. Replace it with a new one.
PORTEGE R200 Maintenance Manual (960-519) [CONFIDENTIAL] 2-55