4.18 PC card slot 4 Replacement Procedures
4.18 PC card slot
Removing the PC card slot
To remove the PC card slot, follow the steps below and refer to Figure 4-25.
1. Remove the following screws fixing the PC card slot.
• M2×4C S-FLAT HEAD screw x2
2. Remove the PC card slot from the connector CN2110 on the system board.
M2×4C S-FLAT HEAD
PC card slot
CN2110
Figure 4-25 Removing the PC card slot
Installing the PC card slot
To install the PC card slot, follow the steps below and refer to Figure 4-25.
1. Connect the PC card slot to the connector CN2110 on the system board and secure it
with the following screws.
• M2×4C S-FLAT HEAD screw x2
PORTEGE R200 Maintenance Manual (960-519) [CONFIDENTIAL] 4-37
To Next Page
Loading...
