Toshiba Portege R200 - Lan;Modem Jack

4 Replacement Procedures 4.19 LAN/Modem jack
4.19 LAN/Modem jack
Removing the LAN/Modem jack
To remove the LAN/Modem jack, follow the steps below and refer to Figure 4-26.
1. Disconnect the LAN cable from the connector CN4100 on the system board.
2. Remove the LAN/Modem jack from the slot.
CN4100
LAN/Modem jack
LAN cable
Figure 4-26 Removing the LAN/Modem jack
Installing the LAN/Modem jack
To install the LAN/Modem jack, follow the steps below and refer to Figure 4-26.
1. Install the LAN/Modem jack to the slot.
2. Connect the LAN cable to the connector CN4100 on the system board.
4-38 [CONFIDENTIAL] PORTEGE R200 Maintenance Manual (960-519)