4 Replacement Procedures 4.7 Switch board
4-20 [CONFIDENTIAL] PORTEGE R200 Maintenance Manual (960-519)
Installing the Switch board
To install the switch board, follow the steps below and refer to Figure 4-10.
1. Connect the switch cable to the connector CN3270 on the system board.
2. Install the switch board according to the guide and secure it with the following
screw.
• M2×2.5C S-FLAT HEAD screw x1
3. Install the switch cover.
4. Turn over the computer and secure the switch cover with the following screw.
• M2×8S BIND screw x1
To Next Page
Loading...
