4 Replacement Procedures 4.9 Cover assembly/Battery latch assembly
5. Remove the following screws and battery latch assembly.
• M2×2.5B S-FLAT HEAD screw x3
Battery latch assembly
M2×2.5B S-FLAT HEAD
M2×2.5B S-FLAT HEAD
Figure 4-15 Removing the battery latch assembly
Installing the Cover assembly/Battery latch assembly
To install the cover assembly/battery latch assembly, follow the steps below and refer to
Figure 4-13 to 4-15.
1. Install the battery latch assembly and fix it with the following screws.
• M2×2.5B S-FLAT HEAD screw x3
2. Install the cover assembly to the base assembly and secure it with the following
screws.
• M2×4B S-FLAT HEAD screw x2
3. Turn over the computer and secure the following screws.
• M2×4S BIND screw x13 (“4” in the figure 4-13)
• M2×3S S-FLAT HEAD screw x1 (“3” in the figure 4-13)
4-26 [CONFIDENTIAL] PORTEGE R200 Maintenance Manual (960-519)
To Next Page
Loading...
