4 Replacement Procedures 4.20 System board
M2×3C S-FLAT HEAD
System board
Audio cover
4-40 [CONFIDENTIAL] PORTEGE R200 Maintenance Manual (960-519)
Figure 4-27 Removing the system board
Installing the system board
To install the system board, follow the steps below and refer to Figure 4-27.
1. Install the audio cover.
2. Install the system board and secure it with the following screws.
• M2×3C S-FLAT HEAD screw x2
3. Connect the LED cable to the connector CN3260 on the system board (front).
4. Connect the LCD cable and FL cable to the connectors CN5600 and CN5601 on the
system board.
LED cable
FL cable
LCD cable
To Next Page
Loading...
