Toshiba RAS-10G2KVP Series - When indoor unit lamp blinks

35
8  C
PURE
TEMP.
PRESET
When indoor unit lamp blinks
Turn off the power supply. Wait 30 seconds. Turn on the power supply and check the operation of the unit.
If the lamp blinks again, inspection and repair is required
Torepairquickly,checkthestatusoftheairconditioneraccordingtothefollowingprocedure
and inform (1) – (3) the supplying supplying retail dealership.
1 Problems with the air conditioner.
2 Check code found by the remote control (See process below).
3 Blink status of the lamp in the display portion of the indoor unit
1
Press the CHECK button with the tip of a pencil to set the remote
control to the service mode.
•
Temperature display setting switches to 00.
•
is displayed.
2
Press or .
•
is displayed in the remote control display.
•
Press or button.
If there is no fault with a code, the indoor unit will sound “Pi” once and the display of the remote control will
changeasfollows:
 •TheTIMERindicatoroftheindoorunitwillashcontinuously.(5timesper1sec.)
 •Checktheunitwithall52checkcodes(
to ) as shown in below table.
 •Press
or button to to move the check codes backward.
If there is a fault, the indoor unit will “Pi” for 10 seconds (Pi, Pi, Pi ...).
Note the check code on the display of the remote control.
 •Thedisplaywillindicatea2-digitalphanumericcode.
 •Allindicatorsontheindoorunitwillash.(5timesper1sec.)
3
Press to clear.
•
Remote display returns to the display before the service mode. Check other codes by repeat the process
1 - 3.
Notes
•
Check codes may not be displayed depending on the kind of fault such as an electrical parts fault.
•
If the check codes are checked when the lamp is not blinking, the correct error code may not be displayed.
•
Do not disassemble or repair yourself. Consult the supplying retail dealership.
Check Codes Table
Check codes not listed in the table may be detected.
Abnormal indoor unit (including wiring fault).
Abnormal outdoor unit (including compressor and others).
Check codes consist of digits and
letters.
Problem with indoor unit (including wiring fault).
Problem with outdoor unit (including compressor and others).