Toshiba RAS-B10J2FVG-E - Concealed Installation

EN
ES
FR
IT
DE
PT
PL
CZ
RU
CR
HU
TR
NL
GR
SV
FI
NO
DK
RO
BG
EE
LV
SK
SI
9
Mounting directly on the fl oor
1) Fix the leg of indoor unit on the fl oor with 2 mounting screws.
2) Fix the upper part of indoor unit on the wall with 4 mounting screws.
(Floor installation)
6 screw
(M4 × 25L)
Slit
NOTE
• In case the plinth is fi xed to the wall, please make sure to cut out the slit
on the left and right side of the main part.
Cut dot-line area
Installation on the wall
1) Fix the installation plate on the wall with 4 mounting screws.
2) Hook the indoor unit on the installation plate.
3) Fix the upper part of indoor unit on the wall with 4 mounting screws.
(Wall installation)
4 screw
(M4 × 25L)
15
4 screw
(M4 × 25L)
1000 mm or less
10
230
670
15
40288
150
CAUTION
Make sure to fi x it at a designated position with the screws.
Failure may result the damage of piping by the turning over of a set.
Concealed Installation
The special method to install the indoor unit bury in the wall is shown here.
Please make sure to change to wall burying mode.
1. To switch to the wall burying mode
To switch to the wall burying mode, press and hold AIR OUTLET
SELECT button for 20 seconds.
- When the operation set up and 5 beep sounds. Then indication at
Temperature indicator will light up for 5 seconds.
- To cancel, press AIR OUTLET SELECT button for 20 seconds then,
5 beep sounds. Then indication at Temperature indicator will blinks for
5 seconds.
- To prevent dewfall, above plate angle should be narrow.
A
For prevent dewfall
Wall burying mode
2. Wall hole size
Wall hole size should be enough to keep the distance with indoor unit as
shown in the following fi gure.
(Front view) (Side view)(Unit : mm)
70 or more
800 or more
(700)
240 to 250
Wall
Floor
20 to 30
Wall
Floor50 or moreIndoor unit50 or more
670 or more
(600)
3. Installation using the supporting plate
• To install into the existing wall hole, if it is impossible to keep 20-30 mm
of depth, use the supporting plate for securing the distance.
• Arrange the screw positions and supporting plate as shown in the
fi gure.
• Be sure to switch to wall burying mode.
(Rear screws potion) (Side view)
(Field supply)
(Field supply)
: Screw holes (Unit : mm)
670
272
240 340
560