Toshiba RAS-B13N3KVP-E - Remote-A or B Selection

Item
14. Self-Cleaning
function
Operation flow and applicable data, etc.
• Self-Cleaning diagram
Description
Operation display ON OFF OFF
FCU fan
ON ON
OFF
rpm is depend on presetting. (500RPM)
FCU louver OPEN OPEN (12.7º) CLOSE
Timer display
ON or OFF
ON
ON or OFF
depend on presetting of timer function. depend on presetting of timer function.
Compressor
ON or OFF
OFF OFF
depend on presetting per room temperature.
CDU fan ON or OFF
OFF OFF
depend on presetting per room temperature.
Cool mode or dry mode
operation more than 10 mins.
Self-Cleaning mode
operate 30 mins.
Automatically turn-off.
Operation time
Turn off by remote controller or
timer-off function.
− 40 −
FILE NO. SVM-12051
15. Remote-A or B
selection
1. Purpose
This oper
ation is to operate only one
indoor unit using one remote controller
.
2.
Description
When oper
ating one indoor unit in a
situation where tw
o indoor units have
been installed in the same room or
nearb
y rooms, this operation prevents the
remote controller signal from being
receiv
ed simultaneously by both units,
thus pre
venting both units from operating.
3.
Operation
The indoor unit on which the remote
controller selection has been set to B
receiv
es the signal of the remote control-
ler also set to B
.
(At the f
actory the remote controller
selection is set to A on all the indoor
units
. There is no A setting display.)
Setting the remote controller
To separate using of remote control for each indoor
unit in
case of 2 air conditioner are installed nearly.
Remote Control B Setup.
1) Press RESET button on the indoor unit to turn
2) P
oint the remote control at the indoor unit.
3) Push and hold CHK
•
button on the Remote
Control by the
tip of the pencil. "00" will be shown
the air conditioner ON.
shown on the display.
4)
Press MODE • during pushing CHK • . "B" will
show on the
display and "00" will disappear and
the air conditioner will
turn OFF. The Remote
Control B is memorized.
Note : 1.
Repeat above step to reset Remote Control
to be A.
2.
Remote Control A has not "A" display.
3.
Default setting of Remote Control from
factory is A.