– 70 –
How to open the screw cap
Fig. 9-2-18
• Place your finger on the lower part and push to
open the screw cap.
• Remove the connector cover.
(1) Remove the screws securing the connector
cover.
• Remove the electrical parts cover.
(1) Remove the screws securing the electrical
parts cover.
• Change the remote controller selector
switch to [B].
(1) Pull out P.C. board from the electrical parts box
up to the place where the remote controller
selector switch can be observed.
(2) Change both switches.
(3) Return the P.C. board to original position.
• Mount the electrical parts cover and the
connector cover each with screws.
• Mount the front panel.
After fastening the two screws, one each at the left
and right of the air outlet, be sure to push the
upper center (1), right end (2), left end (3) and the
lower center part (4) of the air outlet, and confirm
that no gap is left between the front panel and the
rear plate.
• If cooling (dry) operation is made without
pushing the air outlet, dew can be deposited on
the front panel surface. In addition a gap be-
tween the front panel and the rear plate will
become wilder, spoiling the appearance.
• Adhesion of B label (When setting to [B])
Be sure to adhere the B label above the label
and on the remote controller.
Fig. 9-2-19
• How to set the remote controller selector
switch
Fig. 9-2-20
Screws
Connector cover
Electrical parts cover
Pull out
P.C. board
Switch
(Selector switch)
B label
Color label
8
A setting B setting
ON ON
12 12
To Next Page
Loading...