– 62 –
8-5. Remote Controller
8-5-1. Parts Name of Remote controller
TEMP .
MODE
FAN
FAN ONLY
AUTO
COOL
DRY
AUTO
LOW
MED.
HIGH
Hr.ON OFF TIMER
˚C
B
This mark is indicated
when the ECONO.
button is pushed.
Selected degree of air
flow (HIGH, MED., LOW
or AUTO) is indicated.
Selected operation
mode with the MODE
button is indicated.
Set temperature
is indicated
(17˚C to 30˚C).
Transmission indicator
This mark is indicated
when a button is pushed.
Transmitter
TEMP.
(Temperature) buttons
Push this button to set a desired
temperature.
FAN
(Fan speed) button
Push this button to change air flow.
SET
button
Push this button to change wind
direction.
ECONO.
(Economy) button
Push this button to operate
economically.
CHK
(Check) button
Service man pushes this b utton to
check the location of a prob lem.
CNL
(Cancel) button
Push this button to cancel
reservation of timer operation.
RSV
(Reserve) button
Push this button to reserve timer
operation.
START/STOP
button
Push this button to start/stop the
air conditioner.
AUTO
(Auto louver) button
Push this button to swing the
vertical air flow louvers automatically.
MODE
(Mode select) button
Push this button to select an
operation mode.
ACL
button
Push this button when the batter ies
of the remote controller have been
replaced.
ON
(On timer) button
Push this button to start the unit at
the time set by the timer.
OFF
(Off timer) button
Push this button to stop the unit at
the time set by the timer.
MODE
TEMP .
FAN
START/STOP
ON OFF
RSV CNL
FAN ONLY
AUTO
COOL
DRY
AUTO
LOW
MED.
HIGH
TIMER
ACL
CHK
MODE
ECONO.
Hr.ON OFF TIMER
˚C
B
TEMP.
AUTO
SET
FAN
Set time for
timer operation
is indicated.
TEMP .
MODE
FAN
AUTO
COOL
DRY
HEAT
AUTO
LOW
MED.
HIGH
Hr.ON OFF TIMER
˚C
B
Selected operation mode with
the MODE button is indicated.
8-5-2. Name of Indications on Remote controller
All indication that appear on the remote controller are shown for explanation.
<Cooling only model> <Heat pump model>
To Next Page
Loading...