– 60 –
8-1-4. Function Selection Setup
<Procedure> Perform setting while the air conditioner stops.
1
2
3
4
5
6
In STOP status push [MENU] and [▼] buttons simultaneously for at least 10 seconds.
• In the air-conditioning group control mode, and the indoor unit No.1-N are displayed first. 1 is
the piping system address (the value of the refrigerant piping system is the same as the number of
outdoor units, and one outdoor unit is displayed as 1). The indoor unit address represented by N is
the main indoor unit address.
• In the non-group control mode (only one indoor unit), only 1-1 is displayed on the left.
Push [▼] or [▲] button to adjust the indoor unit number. The indoor unit number in the
group control will be changed cyclically. Select an indoor unit to change the settings and
push [TIME] button to confirm.
The fan of the selected indoor unit starts its operation and the swing operation of the louvers starts after
confirmation.
Using [▼] or [▲] button, select the CODE No. [**] to be set.
Use [MENU] button to adjust the flash from CODE No. to SET DATA on the left. Select the
specified SET DATA [****] as required.
(Set the SET DATA of CODE No. [33] from [0000] to [0001], and change the unit of the temperature on
the remote controller from “°C” to “°F”.)
Push [MENU] button to adjust the flash to CODE No. on the right after pushing [TIME]
button to confirm.
• To change the settings of another indoor unit, push [ON/OFF] button to close the current setting, and
repeat from step 1.
• To change other settings of the indoor unit, repeat from step 3.
Push [ON/OFF] button to complete the setting when the setting is completed.
When [ON/OFF] button is pushed, flashes, then the display disappears and the air conditioner
enters the normal stop mode.
(When flashes, it cannot receive operation instructions from the remote controller.)
SET DATA [MENU] [TIME] [▼] [▲] [ON/OFF] CODE No.
[MENU] [TIME] [▼]
[▲] [ON/OFF]
To Next Page
Loading...
