4 Replacement Procedures
4-40 Minnesota 10M/10MG Series Maintenance Manual
4.14 WLAN antennas
To remove the WLAN antennas, first remove the display assembly, display mask, FL inverter
board and the LCD display module. Then follow the steps below.
1. Remove the three square tabs securing the WLAN antennas.
Figure 4-46 Removing the WLAN antennas
Installing the WLAN antennas
To install the WLAN antennas, follow the steps below and refer to the figures in the
preceding sections.
1. Replace the tabs noting the markings on the LCD cover. The black WLAN cable is
arranged to the right, the white WLAN cable to the left, and the gray WLAN cable to the
lower right corner.
2. Make sure all cables are arranged properly in the clamps and use scotch tape to fix the
antennas in the four corners.
To Next Page
Loading...
