4 Replacement Procedures
Minnesota 10M/10MG Series Maintenance Manual 4-51
4.20 Function Button Board
To remove the function button board, first remove the display assembly, keyboard, and top
cover. Then follow the steps below:
Removing the Function Button Board
1. Turn the top cover. Remove three M2.0x2.5 screws securing the function button board to
the top cover.
Figure 4-61 Removing the Function Button Board screws
2. Insert a thin tool such as a flat screwdriver into the gap between the frame and the
function button board to lever it up from the snaps.
Figure 4-62 Removing the Function Button Board
3. Remove the function button board cable attached to the system board.
To Next Page
Loading...
