Toshiba Strata DK 16 - Page 295

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-45-
TABLE RM-AP
PROGRAM 45-2
TOLL RESTRICTION DISABLE
ACTIONSTEP DISPLAY/PRINTOUT
1
>MODE PROG
P
Enter the Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 45
P45
Enter Program Number 45
3 P45 2Enter the number 2.
4 P45 2 01 NRefer to the record sheet and enter the required CO line number.
Example: CO line 01, enter 0 1. The system will display
N or Y to define if the LED is on or off.
5
P45 2 01 N Y
P45 ##
P
Refer to the System Record Sheet and change the CO line
status as required (Y or N).
Press SPACE to step to next CO line number.
6 To Exit Program/Store Data
A)
B)
To store data, press CR.
To exit this program, press # # CR.
Press CR.
02 N
P45 2 01 N Y
02 N
TABLE RM-AQ
PROGRAM 45-3 ~ 6
EQUAL ACCESS, SPECIAL COMMON CARRIER NUMBERS, and AUTHORIZATION CODE DIGIT LENGTH
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 45
P45
Enter Program Number 45
3 P45 3 NNNNN
P45 4 00 12
P45
Refer to the record sheet and enter the item number (3 ~ 6).
Example: Item 3, enter 3. The system will display
the present equal access number or EA1 Code.
5
P45 ##
P
Enter code number 4. The system will display present authorization
code digit length. Refer to the System Record Sheet and enter
the required authorization code number digit length.
Example: 12, enter: 1 2 CR.
6 To exit this program, press # # CR.
Press CR.
4 Refer to the System Record Sheet and enter the required number.
Example: 12345, enter 1 2 3 4 5 CR.
P45 3 NNNNN 12345
P45
NOTE:
Items 5 and 6 are entered the same wa
y
as 3 and 4, respectivel
y
.