REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-46-
PROGRAM 45-8 ~ 9
TOLL RESTRICTION OVERRIDE CODE
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE PROG
P
Enter the Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 45
P45
Enter the Program Number 45
3 P45 8 NNNN
P45 8 NNNN 1234
P45 ##
P
Refer to the System Record Sheet and enter 8 or 9 for the
desired code number. The system will display the present
override code number.
5 To Exit Program/Store Data
Press CR.
4 Refer to the record sheet and enter a new number if required.
Example: 1234. Enter: 1 2 3 4.
P45 8 NNNN 1234
A)
B)
To store data, press CR.
To exit this program, press # # CR.
PROGRAM 46–2 ~ 4
TOLL RESTRICTION ALLOWED/DENIED AREA CODES ASSIGNED BY CLASS
ACTIONSTEP DISPLAY/PRINTOUT
1
>MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 46
P46
Enter Program Number 46
5
Press CR.
Refer to the System Record Sheet and enter the area code or
area code group. Single . Group
*
.
Press SPACE to enter more codes.
P46 X Y
ALLOW –
or DENY
6 Press SPACE to temporarily store data. Press CR when
completed.
P46
7
Continue returning to step 3 until all data input is completed for
this program.
8
To Exit this Program
Press # # CR.
P46 ##
P
3 Enter class number (1 ~ 4). P46
Class Number
4 Enter 2, 3, or 4 SPACE P46
ALLOW? or DENY?
• 2
• 3
• 4 SPACE
— to add codes to memory (allow).
— to delete codes from memory (deny).
— to display codes in memory (allowed codes).
2, 3 or 4
To Next Page
Loading...
