Toshiba Strata DK 16 - Page 306

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-56-
TABLE RM-BG
PROGRAM 54
LCR ROUTE DEFINITION
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 54
P54
Enter Program Number 54
3 P54 1
Press CR.
5 P54 12 11 32
P54 ##
P
To Exit Program/Store Data
A)
B)
C)
To store data, press CR.
Continue returning to step 3 until all data has been entered
for this program.
To exit this program, press # # CR.
Refer to the System Record Sheet and enter the required
route plan number (1 ~ 8).
Example: Route plan 1, enter 1.
4 P54 12 11 32Enter Route Definition Number
Refer to the System Record Sheet and enter the required
route definition number (1 ~ 4).
Example: Enter route definition number 2, enter 2.
The system will display the previously entered CO line
group number (1 ~ 8) and the modified digits table number (1 ~ 6).
Refer to the System Record Sheet and enter the CO line
group and modified digit numbers as required, then press CR.
Example: Change the CO line group number to 3 and the
modified digits table to 2. Enter: 3 2 CR.
Enter Route Plan Number
Modified Digit Table No.
CO Line Group No.
Route Definition No.
Plan No.